Friday, December 18, 2009

Making An Outdoor Evergreen Wreath

Making outdoor wreaths is much more simple than the indoor wreaths in the previous "Indoor Wreath" blog post.

For this project you are going to need grapevine dried into a circle, covered wire, thin light wire, pinecones and evergreen branches. You can also add any little red berries and bells that you might have and you will need a big bow.








Start with the same grapevine as in the previous post. The directions are the same as far as making the initial wreath, however, for an outdoor wreath you need to wrap the wire closer. All of the greenery stem will be held in place by the wire, so it needs to be wrapped close for a full wreath.







When you have the wreath completely wrapped with wire and the hanger on the back then you prepare the pinecones. Any pinecones will look good. I have both the short, squat, round ones and the long, curved ones. I am going to use the long, curved ones for this wreath. The pinecones are wired to the wreath so they can withstand outdoor winds.






After you have wired all of the pinecones you plan to use, you can start to attach them to the wreath. Wrap the wire around the wire on the wreath, securing the base of the pinecone. Take a small piece of wire and also secure the top of the pinecone to the wreath, making sure the wire does not show. This will keep the pinecones from coming off in a storm or hanging down if they become loose.



















When all of the pinecones are attached, you begin to add the greenery.





Cut the greenery into small pieces. I have collected both pine and cedar here. It takes a lot to make a wreath, more than you think. I made one large full wreath from one wheel barrow full of greenery. Any everygreen will make a nice wreath. I have also used spruce which looks very nice. I particularly like the cedar due to the sweet scent, but the spruce has a stong everygreen scent that is nice too.






This is about the right size for a wreath. I cut a small pile to start with and continue to cut them as I go.






Stick the bottom of the cut branch piece under the wire. I do across the wreath in one area first, getting the outside of the circle and the inside, as well as the front. It is not necessary to leave spaces for the pinecones as you can cut the tiny pieces hiding the pinecones off the branch later.












Go all the way around the wreath, making it as full as you can. When you have done the entire circle, go back and fill in any open spots until you are happy with the fullness of the wreath.












Using the clippers, remove any small pieces that cover a pinecone. Make sure you leave enough greenery to cover any wire.





When your wreath is completely filled in and finished, it is time to add the bow.



Directions for making a bow are on the previous "Indoor Wreath" blog post.







Wire the bow onto the wreath. You can wire two long pinecones handing down under the bow and some berries above it. You will need to attach wire to any berries, bells or other decorations you want to add. Everything needs to be wired on to withstand the freezing temps and winds outdoors.


3 comments:

The Japanese Redneck said...

Very pretty. Love the detail in your post too!

Sandra said...

Hi Sheryl - gave your blog a nod regarding your excellent directions on making a wreath. Love your blog, it's so clean and crisp!

Sheryl at Providence Acres Farm said...

Thanks guys! I'm so glad you like it!